Return to Products |
|
|
|
|
 |
EasyCut Keeps Cutting When Others Fail High Quality, Effective and
Efficient NEW EasyCut Guards Cut Better and Last Longer |
|
EasyCut has been designed to
prevent the two cutting edges from moving apart. This is how
it works. The guards have cutting edges at the top and
bottom. They clamp around the cutter bar and area bolted
top and bottom. The knife sections are then alternately bolted
right side up and upside down onto the cutter bar. With
EasyCut one section cuts against the bottom cutting edge of the
guard and the next section cuts against the top.
|
||||
|
Easycut Guards Cut Better & Last Longer
|
Unlike other cutting systems there's no
upward pressure on the knife. With the sections alternately
cutting against the top and bottom of the guards the cutting edges
stay close together because the knife remains balanced. You
get top cutting performance from start to finish. And with
the system always in balance, it keeps cutting under more severe
conditions, it's easier to drive and there's less breakage.
With EasyCut the knife can't life and break guards. The small stones which often lift the knife of ordinary cutting systems and break guards cause virtually no problem with EasyCut. If a small stone does get caught it will either stall the system or break an easy to replace bolt on knife section. | ||||
 Click
here to see Price List
|
The design of the easycut guard also eliminates hold down clamps, shims and all of the adjusting that goes with them. Each EasyCut gauard clamps around the cutter bar and is bolted top and bottom. It starts in the correct position and it stays in the correct position. There is nothing to adjust when you install it, nor is there anything to adjust after many hours of use. EasyCut guards are manufactured from heat treated spring steel. They are stronger and last longer, even in stony conditions. |
|
NEW SCH Roller Guide
|
Currently the knife in a cutterbar is supported by a wear plate. The wider platforms and demand for better cutting performance leads to more wear on the knifeback and wear blades. The new SCH Roller Guide solves that problem. The friction on the knifehead is greatly reduced, the knife runs more smoothly and the cutting performance increases. |
|
Reasons to Switch to the new SCH Roller Guide: |
